2-Jaw Bearing Puller 150mm GEKO G02201
Key information
Availability:Dostępny od ręki
Shipping time:immediately
Shipping cost:From 3.29 Euro
catalog number:G02201
Availability:
EAN code:5901477107504
Product condition:New, originally packaged
Guarantee:24 months of consumer protection
Weight:1,10 kg
By purchasing this product, you will receive 79 points from us, which you can use for shopping in our store. This applies only to customers registered in our store.
- Product description
- Product reviews (0)
- Purchase history (1)
2-Jaw Bearing Puller 150mm GEKO G02201
A tool for the safe removal of bearings, gears and other components seated on shafts. The two-jaw design with a cast body provides stability and even distribution of force during pulling.
Technical features
Cast body
The body is produced using casting technology and offers increased resistance to the stresses generated during use. The crack-resistant material ensures a long tool life even under intensive use in workshop conditions.
Adjustable jaws on guide rails
The guide rail system allows the jaw spread to be adjusted smoothly up to 150 mm. The guides prevent the jaws from twisting during use and keep them parallel to the component being pulled, which is essential for even distribution of force.
Two-jaw design
The two-jaw arrangement provides access to components in confined working spaces. Compared with three-jaw pullers, it requires less clearance around the component being pulled, which is useful when working on parts mounted close to other assemblies.
150 mm spread
A maximum jaw spread of 150 mm allows components with an outside diameter of up to approximately 140 mm to be removed. This range covers the typical bearings used in machine drives, gearboxes and the running gear of commercial vehicles.
Technical specification
| Model | G02201 |
| Manufacturer | GEKO |
| Puller type | Two-jaw |
| Maximum jaw spread | 150 mm |
| Body material | Cast |
| Adjustment system | Guide rails |
Applications
- Removing rolling bearings from shafts in industrial machinery
- Pulling gears from the shafts of mechanical gearboxes
- Removing pulleys and V-belts from drives
- Removing bushings seated on shafts
- Pulling flywheels on internal combustion engines
- Removing clutch plates from drive shafts
- Removing keyed or press-fitted components
- Service work in mechanical and automotive workshops
Use and maintenance
Preparation before use
Before starting removal, check the diameter of the component and make sure it falls within the working range of the tool. Adjust the jaw spread so that the puller jaws can hook onto the edge of the component being removed. The jaws should be positioned parallel and symmetrical to the shaft axis.
Pulling technique
Position the forcing screw centrally on the end of the shaft and tighten it gradually, checking the position of the jaws. Apply force evenly to avoid misaligning the component. For components that are firmly seated, apply a penetrating fluid to the joint and wait a few minutes before trying again.
Tool maintenance
After use, clean the puller of dirt and grease. The thread of the forcing screw and the jaw guides should be lubricated periodically with lithium grease to ensure smooth adjustment. Store the tool in a dry place, protected from moisture and mechanical damage.
Commercial information
Nobody has written a review for this product yet. Be the first to write a review.
Write a review for this product and you will receive 100 points from us that you can use for shopping in our store. This applies only to customers logged in and registered in our store.
Only registered customers can write product reviews. If you have an account in our store, log in to it, if not, create a free account and write a review.
Client: Ba...na,date of purchase 17-08-2023 09:10
