Grout Float 250 mm GEKO G66043
Key information
Availability:In stock (ready to ship)
Shipping time:immediately
Shipping cost:From 3.29 Euro
catalog number:G66043
Availability:
EAN code:5901477134227
Product condition:New, originally packaged
Guarantee:24 months of consumer protection
Weight:0,16 kg
By purchasing this product, you will receive 13 points from us, which you can use for shopping in our store. This applies only to customers registered in our store.
- Product description
- Product reviews (0)
Grout Float 250 mm GEKO G66043
A tool designed for applying and pressing grout into the joints between ceramic tiles. The flexible rubber base spreads the grout evenly without the risk of damaging the tile surface.
Key features
Working width 250 mm
A versatile size that allows larger areas to be covered efficiently while keeping the tool fully under control. It performs well when grouting both wall and floor tiles of standard dimensions.
Rubber base
The flexible material adapts to uneven surfaces and presses the grout deep into the joints. The rubber does not scratch glazed or porcelain tiles, and its balanced hardness allows excess material to be removed in a single pass.
Wooden handle
The natural material provides an ergonomic grip and good control of pressure during work. Wood absorbs vibration and does not slip in the hand, which matters during many hours of grouting.
Mechanical durability
The construction withstands intensive work on site. The rubber is resistant to abrasion and to contact with the chemical components of grout, while the wooden handle is protected against moisture and cracking.
Technical specification
| Model | G66043 |
| Manufacturer | GEKO |
| Working width | 250 mm |
| Base material | Flexible rubber |
| Handle material | Wood |
| Tool type | Grout float |
Applications
- Grouting ceramic wall and floor tiles
- Applying grout to porcelain and terracotta tiles
- Filling joints between clinker tiles
- Finishing work in bathrooms and kitchens
- Grouting mosaic and small-format tiles
- Renovating old joints – applying new grout
- Work on clinker tile façades
Use and maintenance
Preparation before use
Before first use, check that the rubber base is clean and free from any contamination that could scratch the tile surface. The grout should have the consistency of a thick paste – if it is too thin it will run, and if it is too thick it will be difficult to press into the joints.
Grouting technique
The material is applied to the tile surface and then pressed into the joints with the grout float, working diagonally across the joint lines at an angle of about 45 degrees. This method ensures that the gaps are completely filled. Once the joints are filled, the excess grout is collected with the same tool, running it along the joints.
Cleaning after use
Set grout is difficult to remove from rubber, so the tool should be washed immediately after finishing work. Water and a sponge or brush are sufficient. Do not use solvents, which may damage the rubber. The wooden handle should be dried to prevent it from cracking.
Commercial information
Nobody has written a review for this product yet. Be the first to write a review.
Write a review for this product and you will receive 100 points from us that you can use for shopping in our store. This applies only to customers logged in and registered in our store.
Only registered customers can write product reviews. If you have an account in our store, log in to it, if not, create a free account and write a review.
