SDS PLUS Drill Bit 25/450mm GEKO G62545
Key information
Availability:Temporarily out of stock — ask for availability
Shipping cost:From 3.29 Euro
catalog number:G62545
Availability:
EAN code:5901477112638
Product condition:New, originally packaged
Guarantee:24 months of consumer protection
Weight:0,66 kg
By purchasing this product, you will receive 51 points from us, which you can use for shopping in our store. This applies only to customers registered in our store.
- Product description
- Product reviews (0)
SDS PLUS Drill Bit 25/450mm GEKO G62545
Hammer drill bit with an SDS-Plus shank, designed for drilling holes in concrete, reinforced concrete and masonry. The 25 mm diameter and 450 mm working length make it possible to drill deep holes for chemical anchors, services and service penetrations.
Technical features
SDS-Plus shank system
A standard shank used on hammer drills. It allows rapid, tool-free bit changes and locks into place automatically. Compatible with most hammer drills up to 5 kg.
Tungsten carbide tip
The cutting tip is made of tungsten carbide – a material with a hardness of 1500-2000 HV that resists abrasion when drilling concrete and stone. It stays sharp far longer than tool steel.
25 mm diameter
A size suited to fitting M16-M20 anchors, installing pipes up to 20 mm in diameter and creating penetrations for electrical cables and plumbing and drainage services.
450 mm working length
Allows drilling through walls up to 40 cm thick and creating deep holes for chemical anchors in solid structures. The overall length of the drill bit is approximately 510-520 mm.
Technical specification
| Model | G62545 |
| Drill bit diameter | 25 mm |
| Working length | 450 mm |
| Shank type | SDS-Plus (10 mm) |
| Body material | Tool steel |
| Tip material | Tungsten carbide |
| Intended use | Concrete, reinforced concrete, masonry, natural stone |
| Drilling mode | Hammer drilling |
Applications
- Fitting M16-M20 chemical and mechanical anchors in concrete
- Creating service penetrations through load-bearing walls
- Installing ventilation and air-conditioning pipework
- Drilling holes for electrical cables and plumbing services
- Work on installing façade fixing systems
- Preparing holes for service ducts in walls
- Fitting steel structures in concrete foundations
Compatibility
The drill bit requires a hammer drill with an SDS-Plus chuck. It does not fit cordless drill/drivers or drills with a keyless chuck. Before buying, check the chuck type on your drill – an SDS-Plus shank is 10 mm in diameter and has distinctive grooves.
Use and maintenance
Apply steady, moderate pressure while drilling – excessive force reduces efficiency and accelerates tip wear. In reinforced concrete, if you hit the reinforcement, reduce the speed and increase the impact rate.
After use, clean concrete dust off the drill bit with compressed air or a brush. Periodically lubricate the SDS-Plus shank with graphite grease – this prevents it jamming in the drill chuck.
Store drill bits in a dry place, protected from impact. A damaged carbide tip (chipping, cracking) means the drill bit must no longer be used.
Commercial information
Nobody has written a review for this product yet. Be the first to write a review.
Write a review for this product and you will receive 100 points from us that you can use for shopping in our store. This applies only to customers logged in and registered in our store.
Only registered customers can write product reviews. If you have an account in our store, log in to it, if not, create a free account and write a review.
Concrete drill bits sds + 4 cutting edges 16x450mm DT9683 DeWALT
SDS Plus Masonry Drill Bit for Concrete 20 x 600 mm X-TIP YT-4281 YATO